Hyundai Azera 2005, Руководство пользователя

Страница: 262 / 297

6
DO-IT-YOURSELF MAINTENANCE
26
HEADLIGHT AIMING
ADJUSTMENT
G290A01TG-GAT
G290A01NF
Before performing aiming adjustment,
make sure of the following.
1. Keep all tires inflated to the correct
pressure.
2. Place the vehicle on level ground
and press the front bumper & rear
bumper down several times. Place
vehicle at a distance of 3m (118
in.) from the test wall.
3. See that the vehicle is unloaded
(except for full levels of coolant,
engine oil and fuel, and spare tire,
jack, and tools). Have the driver or
equivalent weight placed in driver's
seat.
Vertical
aiming
Horizontal
aiming
4. Clean the headlight lenses and turn
on the headlights (Low Beam or
High Beam).
5. Open the hood.
6. Draw the vertical line (through the
center of each headlight beam pat-
tern) and the horizontal line (through
the center of each headlight beam
pattern) on the aiming screen.
And then, draw the parallel line at
30 mm (1.18 in.) under the hori-
zontal line.
7. Adjust each cut-off line of the low
beam to the parallel line with a
phillips screwdriver - VERTICAL
AIMING.
8. Adjust each cut-off line of the low
beam to the each vertical line with
a phillips screwdriver - HORIZON-
TAL AIMING.
NOTE:
Grinding noise from the power
steering pump may be heard im-
mediately after the engine is started
in extremely cold conditions (be-
low - 20°C). If the noise stops dur-
ing warm up, there is no abnormal
function in the system. It is due to a
power steering fluid characteristic
in extremely cold conditions.
Recommended Fluid
Use PSF-3 type fluid.
NOTE:
Do not start the engine when the
power steering oil reservoir is
empty.
G240A01A-AAT
POWER STEERING HOSES
It is suggested that you check the
power steering hose connections for
fluid leakage at regular intervals. The
power steering hoses should be re-
placed if there is severe surface crack-
ing, pulling, scuffing or worn spots.
Deterioration of the hose could cause
premature failure.