3
WHAT TO DO IN AN EMERGENCY
7
D060C01A-AAT
2. Block the Wheel
Block the wheel that is diagonally op-
posite from the flat to keep the vehicle
from rolling when the car is raised on
the jack.
HTG4009
Flat tire
D060E01A-AAT
4. Put the Jack in Place
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the drawing.
D060D01A-AAT
3. Loosen Wheel Nuts
The wheel nuts should be loosened
slightly before raising the car. To loosen
the nuts, turn the wrench handle coun-
terclockwise. When doing this, be sure
that the socket is seated completely
over the nut so it cannot slip off. For
maximum leverage, position the
wrench so the handle is to the left as
shown in the drawing. Then, while
holding the wrench near the end of the
handle, push down on it with steady
pressure. Do not remove the nuts at
this time. Just loosen them about one-
half turn.
HTG4011
D060E01TG
Содержание Azera 2005
