10
11
15. Way to register wireless transmission / reception
communication device module for door lock (Optional)
12. Pattern register / editing method (In pattern mode setting)
Password / Pattern mode setting (editing) method
※
Leaving door open, press CLOSE button for 3 seconds. Press number 2 on keypad
then you can hear configuration alarm.
※
All numbers on keypad will lighten up in password using mode.
※
0, # will not lighten up during pattern mode.
※
Diagonal drag pattern is not available.
※
If pattern mode is configured, a new pattern must be newly registered.
※
If password mode is configured, the password must be newly registered.
※
Pattern and password cannot be used simultaneously.
Opening door with pattern
※
Touch keypad to lighten up numbers. Drag registered pattern to open door.
➊
Open battery cover in the inner main body and press
①
Register button.
➋
Drag a pattern on keypad using numbers 1-9. (4-12 digits)
➌
Press “
” and re-draw pattern(double check).
➍
Press
①
Register button to complete registration.
13. Registration of remote controller
(Communication device) (Optional)
➊
Open the battery cover on the indoor unit of the door lock (the indoor part) with the door open,
and press the registration button
②
on the right bottom side.
➋
On the screen, the numbers 1, 2, 3, 7, 8, 9 are lit.
➌
Press “2”.
➍
Press the “OPEN” button of remote controller.
(continuous registration possible)
➎
Press the registration button
②
on the indoor unit (the remote controller registration finished).
※ You can register up to 3 remote controllers
※ If you add one, you have to delete and register all in order
14. Way to delete all the remote controllers
(Communication devices) (Optional)
➊
Open the battery cover on the indoor unit of the door lock(the indoor part) with the door open,
and press the registration button
②
on the right bottom side.
➋
On the screen, the numbers 1, 2, 3, 7, 8, 9 are lit.
➌
Press “8” on the screen, “#” is lit.(the remote controller deletion ready)
➍
When you press and hold “#” for 3 seconds, all the remote controllers will be deleted,
with a notification sound.
16. Battery replacement method
1. Battery life time :
4M to 8M upon 10times using a day.
2. Battery change alarm :
Blinking red lights with melody.
Open battery cover and replace all 4PCS of 1.5V AA at once. Make sure its polarity.
3. Emergency power supply :
After battery is fully discharged,
place 9V battery on emergency power contact and open the door with password or RF card.
Max 8PCS
of 1.5V AA
batteries
inserted
In case of Battery gone,
you can put 9V battery
on front cover
as emergency power
source
Emergency
power contact
➊
Press right side button
Bleep sound comes out~~
and press number 2
outside.
➌
Press right side button.
➋
Press Setting button for 5 sec on remote
controller and you will hear long beep sound.
※
Video door phone screen should be on while
registration
1. Red +
2. Black -
3, 4 Door release wires
Setting button
Remote
controller
※ If you add one, you have
to delete and register all
in order (Include remote
controller)
How to use
