Hyundai power products HYC1600E, Инструкция по эксплуатации, Страница: 30 / 48

30
Working
5. Ensure the saw chain is running at full speed before it makes contact with the wood. Use
spiked bumper to secure the product onto the wood before starting to cut and use it as a
leverage point while cutting (See below).
6. Reset the spiked bumper at a low point when cutting thicker logs by pulling the product slightly
backwards, until the gripping teeth release and re-position at lower level to continue sawing. Do
not remove the product completely from the wood.
7. Do not force the saw chain while cutting, let the chain do the work using the gripping teeth to
apply minimal leverage pressure.
8. Do not operate the product with arms fully extended or attempt to saw areas which are difficult
to reach, or on a ladder. Never use the product above shoulder height (See below).
9. Optimum sawing is achieved if the chain speed remains constant during cutting.
10. Be careful when reaching the end of the cut. The weight of the product may change
unexpectedly as it cuts free from the wood. This can cause accidents to the legs and feet.
Always remove the product from a wood cut while the product is running.
11.Check that the oil feed to the chain is operating correctly; run the chain saw at medium speed
and ensure that the chain has received a consistent coating of oil.
Basic Cutting Procedure (Continued)