HYTROL ProSort SC1, Руководство по установке и обслуживанию

Страница: 10 / 36

• Spur Installation/Placement
The ProSort SC1 and ProSort SC2 sorters may be supplied with or without
special slaved powered spurs at the diverters. This section explains how to
properly place any spur and how to properly install the spur drive o-ring on
slaved powered spurs.
SPUR PLACEMENT
1. mount the spur to the side frame of the sorter using the supplied brackets at
the location shown in Figure 10. It may be necessary to drill a hole in the top
flange of the conveyor frame to accept the spur bracket mounting bolt.
2. Check to make sure that the spur is mounted at the proper height. (Proper
height is determined by laying a straight edge on sorter belt, spur rollers or
1st roll of skatewheels should be level with sorter belt). This should be done
to insure the proper diverting of packages. If the spur is a gravity spur, make
sure that the spur is set at a sufficient pitch to properly convey packages
from the sorter.
SPUR DRIvE O-RINg INSTALLATION
1. Route the drive o-ring as shown in figure 10. make sure that the o-ring lies
in the groove of the plastic collar on the spur drive roller and is properly routed
through the idler sheaves as shown.
2. Using a smooth, stiff object, such as a large straight wrench, stretch the
o-ring over and onto the spur drive sheave of the diverter.
3. Visually inspect the o-ring routing. If the spur drive sheave appears to be
out of alignment with the idler sheaves, adjust it by loosening the set screws
in the sheave and sliding the sheave on the shaft until alignment is achieved.
Re-tighten the set screws.
4. Run the sorter and observe the spur for proper operation.
O-RINg REPLACEMENT
If it becomes necessary to replace a roller o-ring or a spur drive o-ring, the
following procedure should be used.
1. Pop the spur drive roller out of the mounting brackets by depressing the
spring-loaded hex shaft of the roller.
2. Slide the new o-ring over the spur drive roller, working it into position
through the existing o-rings.
3. Re-install the spur drive roller in the brackets, taking care to install the roller
shaft in the lower hole of the spur plate bracket and the inside hole in the
discharge end bracket, as shown.
12"
8 3/16"
END BRACKET DISCHARGE
SPUR PLATE BRACKET
INSIDE HOLE OF BRACKET
INSTALL ROLLER SHAFT IN
LOWER HOLE OF BRACKET
INSTALL ROLLER SHAFT IN
IDLER SHEAvE
SHEAvE
SPUR DRIvE
COLLAR
PLASTIC
ROLLER
SPUR DRIvE
DRIvE O-RINg
SPUR MOUNTING BRACKET
C
(plaCa de mOntaJe de la espUela)
(pOlea ImpUlsadOra
de la espUela)
(gUÍa del
anIllO-O)
(Instale el eJe del rOdIllO en el
OrIFICIO sUperIOr del sOpOrte)
(rOdIllO ImpUlsadOr
de la espUela)
(pOlea aCanalada para retOrnO)
(sOpOrte del eXtremO de desCarga)
(Instale el eJe del rOdIllO en el
OrIFICIO InFerIOr del sOpOrte)
(plaCa sOpOrte de la espUela)
(COllar
plastICO)
L
SORTER BELT
(banda del ClasIFICadOr)
FIGURE 10
10