LED Indicator
Description
Glows red
The battery is charging.
Glows orange
The battery is charged to 90% or
above.
Glows green
The battery is fully charged.
Flashes red slowly
The battery fails to make proper
contact with the charger. In this
case, take the battery out of the
charger, and then place it into the
charger for proper contact.
Flashes red rapidly
The battery fails to be charged. In
this case, please contact your
dealer to check whether the battery
or power adapter is damaged.
You can also charge the radio with battery attached.
It is recommended that your radio be turned off
during charging.
Attaching the Battery
1. Align the battery slots with the guide rails on the radio,
and then push the battery until the metal lock reaches the
bottom of the radio.
2. Open the battery latch and exert force on it to retract
the metal lock into the battery housing completely.
3. Push the battery until it is fully fitted into the slot, and
then release the battery latch.
Attaching the Antenna
Do not hold the radio by the antenna, because it
might reduce the radio performance and life span of
the antenna.
Attaching the Belt Clip
1. Use a Phillips screwdriver to turn the screws counter-
clockwise on the back of the radio and remove them.
2. Align the screw holes on the belt clip with those on
the back of the radio.
3. Put the screws back in places as shown below, and
use the Phillips screwdriver to turn them clockwise
until hand tight.
Attaching the Audio Accessory
For optimal waterproof and dustproof performance,
do close the accessory connector cover and fasten
the screw when no accessory is attached.
1. Open the accessory connector cover.
2. Plug the accessory into the accessory connector.
3. Rotate the screw on the accessory plug clockwise
until hand tight.
6
