1. SEAT CUSHION
2. BACK CUSHION
3. BOOT
4. SEAT SUSPENSION
Figure 8. Seat
Install
NOTE:
Use a lifting device to install the seat.
1.
Position the seat onto the seat suspension.
NOTE:
The seat must be positioned completely to
the front to allow access to the two front capscrews
inside the sliding system. The seat must be
positioned completely to the rear to allow access to
the two rear capscrews inside the sliding system.
2.
Install the four capscrews, washers, and nuts
located above the sliding system that retain the
seat to the seat suspension.
3.
Connect the electrical plug located at the
instrument panel side console.
NOTE:
There is one electrical connector on the
mechanical seat. There are two electrical connectors
on the air suspension seat.
4.
Connect the connector(s).
NOTE:
The ground cable is attached with the
capscrew at the right rear corner of the suspension.
5.
Connect the battery ground cable.
Seat Cushion
Remove
1.
Slide the seat forward. See Figure 8.
2.
Adjust the steering wheel upward to its
maximum height position.
3.
Remove and discard the screw from the front
right side.
4.
Remove and discard the three clips from the
cushion front.
5.
Slide the seat fully backward.
6.
Grip the seat cushion on the front right corner.
7.
Lift the seat cushion until the guide block
becomes detached.
8.
Rotate the seat cushion clockwise.
9.
Lift the cushion upward to detach the front of
the seat cushion.
10.
Grip the seat cushion at about the halfway
point toward the rear of the cushion.
NOTE:
Increase the lifting force until the rear of
the cushion detaches.
11.
Lift the seat cushion from right to left.
12.
Cut the cable tie securing the connector block
to the seat cushion.
13.
Disconnect the spade connectors from the
connector block.
14.
Remove and discard the seat cushion.
Install
1.
Feed the cables of the new cushion through the
hole in the armrest bracket.
2.
Connect the spade connectors to the connector
block.
Remove and Install
0100 SRM 2043
8
Содержание RS45-27CH
Страница 1: ...OPERATOR S CAB PART NO 4186391 0100 SRM 2043...
Страница 6: ...THE QUALITY KEEPERS HYSTER APPROVED PARTS...
Страница 21: ......