Hyster RS45-27CH, Руководство пользователя

Страница: 12 / 21

Install
1.
Insert the bolts in the door latch housing.
2.
Install the door latch and install the nuts.
3.
Install the cap screw and washer that retain
the cover to the door latch.
4.
Install the door handle. See Door Handle,
Install.
5.
Make sure the locking system functions
correctly.
PEDALS
Brake and Inching Pedal
Remove
1.
Remove the cover that protects the inch sensor
and switch. See Figure 6.
2.
Remove the rod, located under the inching
pedal.
3.
Disconnect the rod, located under the brake
pedal.
4.
Remove the cap screws, washers, and nuts that
retain the brake pedal and inching pedal
assembly to the bracket at the floor of the cab.
5.
Remove the inching and brake pedal assembly.
6.
Separate the inching pedal from the brake
pedal and remove the three shims.
7.
Remove the two bearings from the inching
pedal.
1. BRAKE PEDAL
2. INCHING PEDAL
3. ROD
4. PROTECTION COVER
5. BEARING
6. SHIMS
7. CAP SCREWS, WASHERS AND NUTS
Figure 6. Brake and Inching Pedals Assembly
Install
1.
Install the two bearings on the inching pedal.
See Figure 6.
NOTE:
Make sure the three shims are positioned
correctly.
2.
Position the three shims and install the inching
pedal to the brake pedal. Check if the roller
under the brake pedal is centered above the
bolt head of the brake valve, adjust number of
shims on each side if needed.
3.
Position the inching and brake pedal assembly
between the brackets at the floor of the cab.
4.
Install the two cap screws, washers, and nuts
that retain the brake pedal to the bracket at
the floor of the cab.
5.
Install the two cap screws, washers, and nuts
that retain the inching pedal to the bracket, at
the floor of the cab.
Remove and Install 0100 SRM 2043
6