Hyster RS45-27CH, Руководство пользователя

Страница: 13 / 21

6.
Connect the rod to the inching pedal.
7.
Connect the rod to the brake pedal.
8.
Check if adjustments to the inching and brake
pedals are required, and adjust as needed.
Refer to the sections Brake Pedal Adjustment
and Inching Pedal Adjustment.
9.
Install the protection cover over the inch sensor
and switch.
Accelerator Pedal and Sensor
1. ACCELERATOR PEDAL
2. CPS04 THROTTLE POSITION
3. IDLE VALIDATION SIGNAL
4. CAP SCREW
Figure 7. Accelerator Pedal
1.
Disconnect the connectors for Throttle Position
and Idle Validation. See Figure 7.
2.
Remove the three cap screws retaining the
accelerator pedal to the cab floor.
3.
Install a new pedal and connect the connectors.
SEAT ASSEMBLY
Seat
Remove
NOTE:
Use a lifting device for the removal of the
seat.
NOTE:
The ground cable is attached with a
capscrew at the right rear corner of the suspension.
1.
Disconnect the battery ground cable.
NOTE:
There is one electrical connector on the
mechanical seat. There are two electrical connectors
on the air suspension seat.
2.
Disconnect the electrical connector(s).
3.
Turn the electrical plug counterclockwise and
disconnect the electrical plug located at the
instrument panel side console.
NOTE:
The seat must be positioned completely to
the front to allow access to the two front capscrews
inside the sliding system. The seat must be
positioned completely to the rear to allow access to
the two rear capscrews inside the sliding system.
4.
Remove the four capscrews, washers, and nuts
located above the sliding system that retain the
seat to the seat suspension.
5.
Remove the seat. See Figure 8.
0100 SRM 2043 Remove and Install
7