Hyster B267, Руководство по обслуживанию и ремонту

Страница: 10 / 40

INSTALL
1.
Install Display Switch Cluster onto steering
column. Install four bolts to secure panel to
steering column and tighten bolts to
19 N•m (168 lbf in). See Figure 5.
2.
Connect the Display Switch Cluster to the dis-
play harness.
3.
Install steering wheel onto steering shaft and
tighten the lock nut until steering wheel is fully
seated. The final torque for the lock nut is 40 to
54 N•m (30 to 40 lbf ft). See Figure 4.
4.
Connect horn wires to horn button. Install horn
lock nut and horn button into steering wheel.
5.
Install upper steering column cover by aligning
the two latches and pushing down until
latched. See Figure 3.
DIRECTION CONTROL LEVER
Remove
NOTE:
The direction control lever is located on left
side of Display Switch Cluster. The direction con-
trol lever is non-repairable and must be replaced as
an assembly. See the Parts Manual for replace-
ment part number.
1.
Insert two small, flat-blade or Phillips screw-
drivers, with a 3.175 mm (0.125 in.) or less,
wide blade or die end, into the opening on the
Display Switch Cluster on an outward angle
enough to compress the spring tab on the direc-
tion control lever. See A, Figure 6.
2200 SRM 1771 Display Switch Cluster
5