Hyster B267, Руководство по обслуживанию и ремонту

Страница: 11 / 40

NOTE: DISPLAY SWITCH CLUSTER SHOWN OUTSIDE OF LIFT TRUCK FOR CLARITY. FLAT-BLADE
SCREWDRIVERS SHOWN.
A. STEP 1 B. STEP 2
1. DIRECTION CONTROL LEVER
2. FLAT-BLADE SCREWDRIVER
3. DISPLAY SWITCH CLUSTER
Figure 6. Direction Control and Turn Signal Removal
2.
Pry the spring tab toward the body of the direc-
tion control lever or turn signal lever and, at
the same time, pull on the handle of the lever
enough to free the tab of the interior lock of the
Display Switch Cluster. See B, Figure 6.
3.
Repeat the previous steps on the opposite side
of the direction control lever. Remove the direc-
tion control lever from the Display Switch Clus-
ter.
Install
Install the direction control lever into the opening
of the Display Switch Cluster until the locking tabs
are engaged in the Display Switch Cluster.
KEY SWITCH
Remove
1.
Fully lower the steering column and remove the
upper steering column cover by pushing in on
both sides of the cover to release the latches
(one on either side), and pulling cover away
from steering column. See Figure 3.
2.
Remove torx head capscrews. See Figure 7.
Display Switch Cluster 2200 SRM 1771
6