Hyster B267, Руководство по обслуживанию и ремонту

Страница: 12 / 40

1. BEZEL
2. OVERLAY
3. KEY SWITCH
4. TORX HEAD SCREW
5. INSERT SCREWDRIVER IN SLOT AT THIS LO-
CATION
Figure 7. Display Switch Cluster Panel Bezel, Grid, and Key Switch Removal
3.
Slide key switch assembly out of Display
Switch Cluster. See Figure 7.
Install
1.
Install new key switch assembly into Display
Switch Cluster. Install torx head capscrews
(T-15) to secure key switch to Display Switch
Cluster. Tighten torx head capscrews to
1.1 N•m (9.7 lbf in). See Figure 7.
2.
Install upper steering cover on steering column.
Align latches on upper steering cover to holes
on steering column and push upper steering
cover into place on steering column.
DISPLAY SWITCH CLUSTER PANEL
BEZEL AND OVERLAY
Remove
1.
Insert a small, flat-bladed screwdriver into the
top slot on the inner edge of the bezel and pry
outward. Repeat procedure at the lower slot on
the bezel. Be careful to not damage bezel and
overlay when removing bezel. Lift bezel off of
Display Switch Cluster. See Figure 7.
2.
Remove overlay from Display Switch Cluster.
Install
Place new overlay on display panel and install a
new bezel by inserting the outer edge in the display
and then pressing down the inner edge.
2200 SRM 1771 Display Switch Cluster
7