Technician Menu
2200 SRM 1324
Power Steering
The Power Steering menu provides the following in-
formation when the truck is equipped with power-as-
sisted steering:
• Torque Input (in inch-pounds)
• Steering Handle Angle (in degrees)
• Battery Input (in volts)
• Steering Motor Current (in amps)
To exit the Power Steering menu, press both the RH
LOWER [#4] and LH LOWER [#1] switches and hold
until the next diagnostic menu is present, or cycle the
key switch to return the lift truck to RUN mode. See
Figure 20.
Figure 20. Power Steering Screen
SERVICE REMINDER
NOTE:
The Service Reminder interval can be
changed from its current setting in 50-hour in-
crements when using the dash display. The intervals
can be further adjusted in one-hour increments if
using ETACC.
Within the Service Reminder menu, you can reset the
Service Reminder, change the service interval hours,
and turn the reminder ON or OFF.
NOTE:
To reset in ETACC in Version 1.29 and below,
take the interval amount and current truck hours,
and add them together. Enter this value under Truck
Hours at Next Service and download.
When the service reminder is ON, the dash display
will display a one-time message to the operator when
the service interval has been reached. The lift truck
will continue to operate normally until the hourme-
ter reaches 20 hours past the designated service in-
terval. At this time the lift truck function speeds will
be reduced until the Service Reminder has been re-
set. See Figure 21. Use the LH LOWER [#1] and
LH LIFT [#2] switches to scroll between the menu
choices. When the proper menu item has been high-
lighted, press the RH LOWER [#4] switch to move to
the selected submenu. Make any changes required
to the menu item. Use the RH LIFT [#3] switch to
return to the Service Reminder menu. Scroll to the
exit options and select. Press the RH LOWER [#4]
switch to return to the Technician Menu. The nor-
mal factory default setting for the Service Reminder
is OFF and must be changed to ON for the Service
Reminder to be active. The interval value shown on
the display is a fixed value denoting the total time
interval between services and DOES NOT change to
show time remaining as the service reminder counts
down.
NOTE:
To turn off service reminder in ETACC Ver-
sion 1.29 and below, enter 0 in Truck Hours at Next
Service and download.
Figure 21. Service Reminder Screen
14
