background image

I

nstaller

s

 C

heCklIst

  

Date Installed: ________________  Gate Operator Model: _________________________________________________________________ 

Site Location: __________________________________________________________________________________________________________  

HyNet Serial Number: ___________________________________

Gate Operator Serial Number: ___________________________

Gate Operator Serial Number: ___________________________

Gate Operator Serial Number: ___________________________

Gate Operator Serial Number: ___________________________

Customer Name: _______________________________________________________________________________________________________

Mailing Address: ________________________________________ 

Inspected by: ____________________________________________

________________________________________________________ 

Date Inspected: __________________________________________

Phone Contact: _________________________________________ 

Phone contact number: ___________________________________

 

Checked Initials

1. Site Planning

 

 

 _____________

RJ-45 cable to system network.

2. Safety

 

 

 _____________

Review 

Important Safety Information

 in the gate operator's product manual.

Warning labels apparent and affixed properly.

Area around the gate and gate operator free of debris, cabinets/chassis include locking mechanism.

3. Electrical

 

 

 _____________

3.1 Grounding

•  NFPA 780 Standard for the Installation of Lighting Protection Systems.
•  Solid copper ground rod (

-inch diameter, 10 ft length) driven into ground within 3 ft of the gate operator.

•  Single length of unspliced 6AWG copper wire less than 3 ft long attached to lug nut in gate operator.

3.2 Gate operator has current software loaded.

3.3 Configure the Controller

•  Set the System Address (SA) in the Installer Menu. 
• 

Communicate (verify) system address to IT Network Admin for proper web page configuration.

4. Review gate operator installation checklist from gate operator manual

 

 

 _____________

5. Take photographs of installation and provide an End User Demo

 

 

 _____________

www.hysecurity.com  

©

 2016 

StrongArmPark DC Installation 

D0719 Rev. C 

  7  

Содержание StrongArmPack DCS 10









Отзывы: