HypnoSquare Instructions v 1.3, May 2009
- 15 -
Because the module does not lie flat when placed upside down for soldering, it can be difficult to mount straight
on the first try. Solder just one corner pin and make sure that it is level and seated all the way before doing the
rest.
Figure 36: USB module in place.
Step 4: The Power Switch
Next, we will attach the power switch. This too goes on the back of the
LED board, although the neat trick here is that it will slot through a
notch cut in the controller board to line up next to the buttons.
Orientation does not matter here, but it is important to make sure that it
is seated properly. You know what I‟m going to say next by now -
solder just one pin down and make sure it‟s seated all the way before
doing the other two.
Figure 37: Power switch.
