HyperPAC™ User Manual
www.hypertech.com
Installing the HyperPAC™
Secure the Suction Cup Mount
The suction cup mount can be adjusted by
loosening the adjustment knobs and moving the
mounting points (fig I). For best results when
mounting, make sure the surface of the windshield
and the suction cup are both clean. Position the
suction cup with the latch pointing down towards
the dash. Press in on the latch in the open position
to extend the suction area away from the plastic
cup. Press the suction cup against the windshield.
Once the suction cup is stuck to the windshield,
press the mount against the cup and secure the
latch (fig J). The cup should be secured on the
windshield. Test by tugging lightly on the mount to
insure it is secure.
Figure I
• (901) 382-8888
Page 5 of 66
Figure J
Mount the HyperPAC™
To mount the HyperPAC™ unit on the mount
base, align the clamp with the platform on the
mount base and lightly press the HyperPAC™ unit
until it snaps into place (fig K). Make sure you have the HyperPAC™ screen positioned
correctly. The power button and speaker vents should be on the right of the unit with
the Hypertech logo at the bottom. Adjust the mount to position the screen in the desired
location, and tighten the adjusting knobs. The platform on the mount base will swivel to
allow for ultimate screen adjustability. To remove the unit, pull the tab on the clamp
towards the HyperPAC™ unit to release the clamp.
Figure K
