2
EN
Safety Instructions
• Clean the probe immediately after each measurement to avoid cross contamination
• Do not expose the appliance to temperatures over 50ºC/122ºF or use in ovens.
Installation
1. Open the battery compartment on the bottom of the appliance.
2. Insert the battery (Negative (-) terminal first).
3. Pull out as much of the probe cable as required.
4. Close the battery cover.
Operation
Temperature Measurement
1. Press the On/Off button
to power up the thermometer.
2. Insert the probe approximately 25mm (1”) into the foodstuff.
3. The temperature of the foodstuff is displayed when the value remains constant.
Units of Measurement
Press and hold the ºC/ºF button for three seconds to alternate between Centigrade and Fahrenheit.
Data Hold
1. Press the HOLD button to keep the current reading displayed.
2. Press the HOLD button again to resume normal operation.
Maximum/Minimum Readings
The thermometer can store and display the maximum and minimum temperature readings taken since
the last reset:
1. Press the MAX/MIN button. The MAX icon flashes and the maximum temperature taken displays
on the screen.
2. Press the MAX/MIN button again. The MIN icon flashes and the minimum temperature taken
displays on the screen.
3. Press the button again to resume normal operation.
Note: To reset the memory turn the thermometer Off and then On again.
Always reset the memory before taking new readings to ensure accuracy.
High/Low Temperature Alarm
The thermometer can sound an alarm when a set temperature range is exceeded.
1. Press the SET button. The HI value flashes on the display.
2. Press the or button until the required maximum temperature is displayed.
3. Press the SET button to confirm. The LO value flashes on the display.
4. Press the or button until the required minimum temperature is displayed.
5. Press the SET button to confirm and return to normal operation.
• When the alarm sounds, press any button to turn it Off.
Note: The appropriate icon on the display (HI or LO) continues to flash until
the temperature returns to within the set range.
• To permanently turn the alarm Off, follow the steps above but pressing the
button when the
HI and LO values flash on the display.
F338_ML_130x210mm_v7_20211213.indb 2
F338_ML_130x210mm_v7_20211213.indb 2
2021/12/13 11:05
2021/12/13 11:05
