15
Remote Measurement
12
Remote Measur
ement
6.2 Transfer of configuration from RFID to reader
Data on the RFID card is transferred and stored to the Cube memory after
being uploaded via RFID. The configuration is still available for further tests
after the measurement.
By briefly pressing the button, the reader will use the stored configuration
and proceed to point 7. If a new RFID card is placed on the reader instead,
the new configuration will be uploaded and will replace the old stored
configuration. Then the reader proceeds to point 7. The configuration is
still stored after turn-off and can be used again after turn-on until it is
replaced with a new RFID transmission.
Attention:
The permanent version of the feature bears the
risk that the currently stored configuration is unknown, and
a wrong test is measured with it which can lead to faulty
results.
7. Test
After a successful RFID transmission of the configuration the display shows
TEST
. Press and hold the button longer than 1 second to show test and lot
specific information of the test to be run. Briefly press the button to return to
TEST
and continue with the measurement process.
8. Start measurement
Start the measurement by briefly pressing the button.
