HYDROSCAND PowerCut 5-85ot, Руководство пользователя

Страница: 10 / 31

Page 10
PowerCut 5-85OT USER MANUAL EDITION II 2017-09-08
6. Maintenance
WARnInG!
When doing maintenance on the machine do always make sure that the machine is unplugged from
the electrical net, pneumatic and do always press down the emergency switch. Taking these safety
measurements ensures that no electrical tension is supplied to the machine that could make it start.
Do always use protecting gloves when changing cutting blade. Do always use protective clothing and
protective shoes to make certain that no injuries will happen if dropping the cutting blade on the
body or feet.
6.1 Replacing the cutting blade
1.
Unplug the machine and press down the emergency switch.
2.
Open the lid on the left side of the machine stand and
open the front hatch.
3.
Loosen the socket set screws and the socket head cap screws,
outer carrier behind the lid.
4.
Dismantle the old blade and assemble a new one. Only use by
hydroscand Machine recommended cutting blades.
5.
Assemble the centre socket head screw tightly;
torque 80 Nm. Tighten the two socket set screws to
secure the cutting blade.
6.
Reassemble the lid and the front hatch. Make sure that all screws are
severally tightened. The correct torque to use is 24 Nm. Use a torque
wrench to be sure the screws are correct tightened.
New cutting blades must be used with reduced speed
for the feeding at about 200 cut. When the running-in
has been done the cut can be performed at normal speed.
As a basic rule the blade should never be overheated.
If excessive smoke or heat is generated or if the motor stalls
the cut sequencemust be interrupted immediately and the
cause found.
Lid
Front hatch