Page 13
h24Ap/hp uSEr mAnuAL EdItIon I 2013-02-20
5.2 Changing the oil
The oil should be changed once per year. Retract the dies.
H24AP: Fill oil to the line on the oil-level glass on the front of the pump.
H24HP: Fill to the line on the oil-stick
Use only the oil recommended by Hydroscand Machine AB:
ISo VG32
H24HP: Oil change, the following must be done:
1. open release crane
2. pump slowly many times
3. close the release crane
4. Air the hose and cylinder by pumping slowly to oil without air bubbles coming at the cylinder.
5. the hand pump is now ready to use.
5.3 Changing the battery
When the light indicator lamp becomes weaker then it is time to change the battery. Open the lid and
replace the battery.
Battery type: 9V
5.4 Calibration
If the actual crimping measurement differs too much from the set crimping measurements then cali-
brate the machine.
1.
Insert a pipe/hose in the machine and crimp.
2.
measure the crimped application thoroughly.
3.
release the setting dial.
4.
turn the setting dial to the crimping measurement previously completed.
5.
return the setting dial.
6.
check. repeat the procedure if the actual crimping measurement differs from the set crim
ping measurement.
Locking mechanism to lock
the set crimping measurement
