Page 12
h24Ap/hp uSEr mAnuAL EdItIon I 2013-02-20
4.6 Crimping
1. Once the desired die set is mounted, place the hose application between the dies.
2. H24HP: Turn the on/off valve dial clockwise until the dial stops. Pump the hand pump
until the indicator lamp lights.
3. H24AP: Turn the on/off valve dial counter-clockwise to contract the dials and release
the hose application.
4. Check the crimped hose and make adjustments if necessary.
5. Maintenance
5.1 Lubrication
The machine should be cleaned and lubricated every eight (8) operation hours. Retract the dies to
lubricate. Use a small brush to lubricate the cone-like surfaces in the cylinder. It is better to
lubricate sparingly and more often than seldom and excessively. Without lubrication, the machine
looses power and can damage the gliding surfaces.
Use only the lubrication recommended by Hydroscand Machine AB:
optimol viscogen 4
WARNING!
Pinch point! Keep hands
clear of the dies when
crimping!
