44
CARTRIDGE FILTER
The cartridge should be cleaned every two to four weeks,
depending on the amount of use. Signs that the filter requires
cleaning include:
• Reduced jet power
• Hazy gray water
• Rattling noise in the pump or filter
• Heater not working
REMOVAL
1
Activate the
STANDBY/DRAIN ASSIST
mode.
2
Remove the filter cover and open the small, black air vent /
bleeder valve on the top of the filter lid.
3
Lift the gray lock tab to disengage and turn the locking ring
counter clockwise.
4
Pull the filter lid upwards, and lift the cartridge elements
straight up and out of filter housing.
5
Separate the inner and outer core from each other by push-
ing the inner core out.
CLEANING
6
With a garden hose and spray nozzle, hose off the cartridge
element, ensuring to carefully separate every pleat.
7
To remove collected lotions, body oils, etc. soak the car-
tridge in warm water and a filter cleaning/emulsifying com-
pound
(available at your
HYDROPOOL retailer).
8
A cleaning cylinder may be purchased from your HYDRO-
POOL Hot tub Retailer.
9
Rinse thoroughly and dry before replacing.
10
Hydropool recommends purchasing a spare filter cartridge
so that you always have a clean substitute ready to rotate.
11
After the element has dried - if necessary, lightly brush
between pleats with a fine paint-brush to remove remain-
ing dirt particles.
Do not use a wire brush or other devise
to clean cartridge element.
Do not put in dishwasher or washing ma-
chine.
RE-INSTALLATION
12
Place the cartridge filter back into the filter housing.
13
Replace the filter housing lid, pushing it down to seat, en-
suring that the lid o-ring does not become twisted.
14
Hydropool recommends that the lid o-ring be lubricated
with a non-petroleum based lubricant (i.e. Silicone gel)
when it becomes dry. This will help to prevent twisting and
pinching as the lid is installed, and significantly increase
longevity of the o-ring.
15
Install the filter lock-ring, turning clockwise until the lock
tab snaps into place.
16
Close the air vent/bleeder valve.
17
Take the system out of
STANDBY/DRAIN ASSIST
mode.
18
When the pump starts circulating on low speed, it will be
necessary to release trapped air in the filter. Carefully
loosen the air vent/bleeder valve counter-clockwise until
there is the hissing sound of air escaping. Once there is a
steady stream of water, close the vent valve, ensuring that
the o-ring does not become pinched.
CLEANING THE ACRYLIC SURFACE
The acrylic surface can be cleaned and polished using a soft
cloth and acrylic cleaner, available at your Hydropool retailer.
• Important: Do not use detergents - the
remaining residues will adversely affect
water chemistry, making it difficult to
maintain proper water balance
• Do Not use abrasive cleaners – damage
to the acrylic surface will occur.
FILTER HOUSING
LOCKING
RIN
G
BUILT IN CHEMICAL
DISPENSER
AIR VENT
VALVE
CARTRIDGE FILTER
ELEME
NT
FILTER LID
INNER CORE
OUTER CORE
Содержание HSC395G
