3
PRECAUTIONS
REVERSE OSMOSIS MEMBRANE DIAGRAM
• Do not install the unit where the source/inlet pressure may be more than 80 psi or
there are excessive water hammer/spike problems. If your inlet pressure is more than
80 psi, install a
3
/
8
" pressure regulator (
HL 10071
see pg. 15), available at your
dealer or through HydroLogic.
• Keep out of direct sunlight or high intensity lights, which degrade the housing and
fittings over time. For added protection use the Algae Block Sleeve (
HL 26009
see
pg. 15) to protect from sun or lights.
• When replacing filter cartridges, use the filter wrench to remove housings. Do not use
the wrench to tighten the housings.
Hand-tighten the housings only.
Take care not to
over-tighten.
• Do not install where leakage or failure may cause damage to property.
• If you are going to store or not use your
for an extended period of time
(2 weeks+), remove your membranes, seal them in plastic and put in refrigerator.
• Protect unit against freezing to prevent cracking of the filter housings and water
leakage.
• Replace both clear pre-filter housings every three years:
HL 23165
from your local
dealer or from HydroLogic.
• Do not drop or place heavy objects on top of unit.
Содержание stealthRO150
Страница 1: ...USER MANUAL...
