6
370 Encinal, Suite 150
Santa Cruz, Ca 9506
0
P: 888-426-5644 / F: 831-336-9840
www.
hydrologicsystems.com
Feed and Drain Connec
ti
on
Feed Connec
ti
on
Note: The feed connec
ti
on pictured on the box may be di
ff
erent from what is included
with the system.
1. Locate and turn o
ff
the angle stop valve on the cold water line feeding the sink. This
valve will usually be located under the sink on the pipe coming out of the wall.
2. When the angle stop valve is closed, relieve pressure in the line by opening the cold
water tap on the sink.
3. Disconnect the feed line at the angle stop valve. With this end of the water line free,
proceed to Step 4.
4. Wrap the threads with Te
fl
on tape and install the feed connector into the angle stop
valve. Then reconnect the cold water feed line to the open end of the feed connector.
Tighten all connec
ti
ons securely.
5. Using the green 1/4” tubing, install the compression nut, plas
ti
c ferrule and plas
ti
c
tube insert. Secure the tubing into the feed connector. Tighten the tubing retaining nut
securely.
6. A
tt
ach the small feed valve warning tag from the parts bag to the feed valve.
7. A
tt
ach the Shuto
ff
Warning label to the system so that it is directly visible. Fill out the
Date of Installa
ti
on label and a
tt
ach to the side of the system.
Drain Connec
ti
on
Note: The drain saddle assembly must be installed before the 'P' trap. Do not install the
drain saddle assembly between the 'P' trap and the wall.
1. Posi
ti
on drain saddle assembly (Fig. 3) on drain pipe under sink between the P trap
and the sink connec
ti
on.
2. Orient the drain saddle so that the connec tor opening points in the general direc
ti
on
of the planned loca
ti
on for the R.O. dispensing faucet.
3. Screw the connector nut onto the drain saddle threaded connector loosely (Fig. 4).
Using the connector opening in the side of the drain saddle as a guide, drill a 3/8" hole
through the wall of the drain pipe.
4. Remove drain saddle assembly. Place the adhesive foam pad over the 3/8" hole in the
drain pipe. Replace the assembly onto the drain pipe, aligning the hole in the drain with
the hole in the drain assembly.
5. Tighten the saddle bolts evenly on both sides un
ti
l the saddle grips the pipe snugly -
do not over
ti
ghten. (Fig. 4)
Fig. 3
Fig. 4
Fig. 1
