HydroCare Quadmaxx, Инструкция по установке, использованию и уходу

Страница: 2 / 5

Parts Included
A. Backing w/ Inlet and Outlet Pipe Manifolds
B. 4 Sleeves w/ Purification Media
C. Media Removal Tool/Manifold Adjuster
D. Wall Mount Screws w/ Anchors
E. Disconnect Clip
F. 1 set of Sleeve Bypass Caps
G. Cap of Silicone Grease
Tools & Parts Needed
■
Level
■
#2 Phillips Screwdriver
■
Adapters from home pipe size and type to 1” Copper
■
If incoming water pressure is over 80 PSI, install a pressure regulator.
Installation Requirements
Install upside down or sideways. All of the arrows on the Sleeves must point in the same
direction from inlet to outlet which is the direction of the water flow.
The system should be located after connection for the outside hose bibs, sprinkler system(s),
and/or irrigation line(s). These lines should be left untreated. Do not use with water that is
microbiologically unsafe or of unknown quality without adequate disinfection before or after
the system.
Install in a location that is not susceptible to freezing temperatures as damage to the Sleeves
could occur. Install away from direct sunlight as prolonged exposure to light can weaken plastic
components.
The system needs to be mounted to a solid surface (Backing is drilled for 16 inches on center).
Wall anchors are provided if needed.
You may consider an optional Bypass Assembly with additional shutoff valves for convenience
when changing your HydroCare Patented Purification Media.
E F