FMMP
Technical specifications
HYDAC Filter Systems GmbH
en
Page 18 / 28
BeWa FMMP 3360764 en 2009-06-05.doc
2009-06-05
e hydraulic system and see whether it is within
the permissible flow range for the CS1000 for the FMMP inlet.
Ensure the flow rate is cont led by
alve and is
regulated to the measurement volum
CS1000 does not correspond t
Connecting the FMMP to Your Sy
Determine the system pressure of th
rol
the integrated flow control v
e of the CS1000. The flow rate displayed by the
o the total flow through the FMMP.
stem
WARNING
H
e under pressure
ydraulic systems ar
Bodily injury
►
The hydraulic system must be depressurized
system.
before performing any work on the hydraulic
Connect the FMMP with the hydraulic system as follows:
ector thread G1/4 ISO 228 or test connection 1604).
Use an internal Ø
≥
4mm for the return flow line.
4.
Now connect the other end of the return line to the system tank, for
example.
5.
Connect the measurement line to the inlet port (IN) of the FMMP.
(connector thread G1/4 ISO 228 of test connection 1604)
Use an internal Ø
≤
4mm to prevent particle deposit.
6.
Connect the other end of the measurement line to the measurement point.
7.
The hydraulic installation of the FMMP is now complete.
1.
Check the pressure at the measurement site. It must be within the
permissible range.
2.
Depressurize the system.
3.
Connect the return flow line with the outlet port (OUT) of the FMMP
(conn
