HDA 4000W intrinsically safe, non-sparking, dustproof enclosure: ATEX and IECEx
9
Status: 2021-11-22
HYDAC ELECTRONIC GMBH
Part
no.: 670063
5.4
Personnel selection and qualification; fundamental responsibilities
• All work on the measuring system must be carried out by qualified personnel only.
• Qualified personnel includes persons, who, through their training, experience and instruction,
as well as their knowledge of the relevant standards, provisions, accident prevention
regulations and operating conditions, were authorized by the persons responsible for the
system to carry out the required work and are able to recognise and prevent from potential
hazards.
• The definition of “Qualified Personnel” also includes an understanding of the standards VDE
0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-Verlag GmbH).
• Clear rules of responsibilities for the assembly, installation, start-up and operation have to be
defined. It is obligatory to provide supervision for trainee personnel!
5.5
Organisational measures
• The user manual must always be kept accessible at the place of use of the measuring system.
• In addition to the user manual, generally applicable legal and other binding accident
prevention and environmental protection regulations must be paid attention to and must be
mediated.
• The respective applicable national, local and system-specific provisions and requirements
must be paid attention to and mediated.
• It is mandatory for the operator to inform personnel on special operating features and
requirements.
• The personnel instructed to work with the measuring system must have read and understood
the user manual, especially the
chapter
5 Safety, prior to commencing work.
• The nameplates and any prohibition or instruction symbols applied on the measuring system
must always be maintained in a legible state.
• Repairs may only be undertaken by the manufacturer or a facility or person authorised by the
manufacturer.
6
Transportation, Packaging, Storage
6.1
Transportation
The HDA 4700 Bluetooth 4.0 LE Sensor is supplied in a rugged cardboard box.
When receiving and unpacking, make sure the item has been delivered in full and look out for any
possible transport damage. If present, immediately show it to the shipper.
6.2
Packaging
Do not remove the packing until you are ready to install the unit.
Keep the packing of the device for eventual reuse in case of transport (changing application areas)
or re-storage, it provides the best protection for the device.
6.3
Storage
Information on the permitted environmental conditions at the place of storage can be found in
chapter
