Hyd-Mech S-23A Скачать руководство пользователя

Страница: 53 / 134

Pg 40

S22A / S23A mits 2001

PLC 100 PARAMETERS

Parameter

DEFINITION

SPEED CONST

WHEEL TRGETS

LTH CLB
(PRESS "ENTER")

ACTUAL LTH

LTH CONST

ACCEL DIST

DECEL DIST

MIN FST DIST

TARGET WINDOW

FVO DWELL

SVO DWELL

CLOSE TIME

FEED RATE

ACTUAL POSITION

HOLD SHT HOME

BRKN PROX

MIN BLD SPEED

SPD PROX DELAY

POWER DWN
TIMER

BLADE CLEAR

TRIM CUT

Blade speed adjustment number.

If Actual Blade speed is different than displayed

Blade Speed a new speed factor will need to be calculated. (Providing wheel Trgs is set
correctly): Actual speed / Display = Adjustment factor X Existing speed factor = New
speed factor.

Number of targets per revolution of the idler wheel.

S20A, S23A, H10/14, M16/20 = 1

H18/22, H28/32 = 6.

Length calibration.

This is to be used only if calibration is required. Call Hyd.Mech

Service department for instruction.

Actual Length Value.

Value entered after performing length calibration procedure

(described later in this section). PLC uses this value to calculate it's length encoder
resolution and stroke parameter.

Note:

If Calibration Procedure is activated and not

completed, or activated and a value not entered for ACT LTH, this value will reset to
00.000 and the PLC will not be able to count/display lengths.

Length constant.

Specifies linear distance of shuttle movement in inches per one

pulse of shuttle encoder.

Shuttle acceleration distance.

Distance, in inches, the shuttle will travel slowly before

reaching fast speed while starting to move in either direction. (i.e. 1.000).

Shuttle decceleration distance.

Distance, in inches, the shuttle will travel slowly

reaching home or target position. (i.e. 1.000)

Minimum fast speed distance.

If programmed length is smaller than this parameter

override to slow speed. (Shuttle)

All/- tolerance

from programmed length.

Delay time

for the opening of the fixed VISE in seconds.

Delay time

for the opening of the shuttle VISE in seconds.

Delay time

for the closing of the shuttle or fixed VISE in seconds.

Activates feed rate display.

Not active on S20A, S23A and H10 machines.

If this value

is set to “YES” displays shuttle vise actual position.

Hold shuttle VISE

home and closed during cut.

Allows user to override signal

from prox switch in case it is broken. (When set to

“NO” machine will not run with broken proximity sensor. Set to “YES” allows machine to
run).

Minimum blade speed

on which blade breakage will be activated.

Delay in monitoring

of the blade speed proximity switch during acceleration of the

blade from start to desired speed set by the potentiometer.

If “0” selected,

then the machine will shut down after the job is completed. This will

allow the machine to continue running for a specified time after the job (in Manual Mode)
or the cyle (in Auto Mode) has been completed.Range from “0” to “180” minutes.

If set to “YES”;

When the AUTO cycle reaches the function of head up, the shuttle will

retract the material from the blade by 1/8" before the head will move up. When the head
reaches the up position the next length of material is shuttled into position.

If “YES” selected

the machine will perform a facing cut of the material at the beginning

of an automatic cycle.

---- Continued ----