Hyd-Mech S-23A, Руководство по эксплуатации и обслуживанию

Страница: 31 / 134

Pg 20
S22A/S23A 2001b 2100 v1.0
NOTE: Whenever a new job or new material is being loaded for production, the head up limit switch should be
properly set (ref pg. 23) to clear the material, material positioned for a trim cut and the front vise closed (in
"MANUAL MODE").
AUTOMATIC OPERATION
When the AUTO/MAN button is pressed, the red indicator light above it will come on, and the blade will stop
if it has been running. The screen will change to the JOB display window as shown below and be ready for
editing or starting a new job. All manual functions will be disabled.
JOB DISPLAY WINDOW
PROCEDURE FOR EDITING OR STARTING A NEW JOB IN AUTO MODE
1)
In AUTO mode, key in a job number from 0 to 99 and press If the job number has previously been
programmed, the REQUIRED QUANTITY (RQ), LENGTH (LTH) and QUANTITY (CT) will be displayed. The
values displayed can be edited by pressing ENTER after each new value, and the job will be stored in memory
with the new values. To navigate through the values, use the CURSOR keys.
2)
After the values are entered, press the
CYCLE START
button, the switch will illuminate, the display window
will prompt you to start the blade for a trim cut (if the “Trim Cut” parameter has been selected).
CAUTION;
If the head is in it’s full down position it will rise to the head up limit so that no damage to the blade
will occur.
3)
After starting the blade, the head will descend for the cut and the machine will complete the required job.
JOB IN PROGRESS
4)
At the completion of the job, the machine will shut down if “0” has been entered in the “POWER DWN TIMER”
parameter or continue running for the specified time up to a maximum of 180 minutes.
NOTES:
1)
The "CT" value is the accumulated total number of parts that have been cut from the JOB number since it
was last reset. The machine will only cut the quantity which is the difference between REQUIRED QUANTITY and
CUT QUANTITY. When REQUIRED QUANTITY equals CUT QUANTITY, the machine AUTO CYCLE will stop and
you will be unable to restart the same job until the "CUT QUANTITY" value has been reset.
2)
The AUTO cycle may exited and stopped at any time by pressing the key.
Length
Cut Quantity
Required Quantity
Job Number