Hyd-Mech H4040, Руководство пользователя

Страница: 19 / 57

2.2
EMERGENCY STOP
Stops blade and hydraulic motors. Head motion will stop and vise clamping pressure will begin to
fall off. Long pieces of work should always be supported so they will not become loose over time
and fall while the machine is shut down. This is a latched button and must be pulled out to start
the machine.
BLADE STOP
When depressed the blade will stop. Blade motor will stop automatically when head reaches
head down limit switch.
HEAD CONTROL
This switch has three positions: UP, HOLD, and DOWN. UP causes head to rise until it
mechanically cannot raise any higher or the switch is moved to HOLD. In HOLD head movement
stops. In the DOWN position the head will descend until it reaches the lower limit switch. The
speed or rate of descent is controlled by the FEED RATE VALVE.
CONVEYOR FORWARD
When depressed, the selected conveyor’s rollers rotate in a direction which would move material
forward from behind the saw head toward the front of the machine. Releasing the push button
deactivates conveyor motor(s) and movement will stop.
FRONT VISE
This switch has three positions, OPEN, NEUTRAL and CLOSE. With the switch held in the
OPEN position the vise will open all the way or until the switch is released. With the switch in the
NEUTRAL position, the vise will stay where it is and will not move freely although it will not resist
a large force indefinitely without creeping. In CLOSE, the vise will close all the way, or until it
encounters enough resistance to stop it.