Hyd-Mech H28A-120, Руководство по обслуживанию и запасным частям

Страница: 44 / 88

2.16
STEP 5: DETERMINE FEED RATE SETTING, FR (in/min) (mm/min).
# MATERIALS OPTIMUM BLADE SPEED
(ft/min) (m/min)
1
5” (125mm) Diameter Solid Carbon Steel
225 70
2
12” (300mm) I-Beam
290 90
3
4” x 4” (100mm x 100mm) Rect. Tube 1/4” (6mm) Wall
350 110
4
4” (100mm) 400 Stainless Steel
140 45
5
2” x 2” (50mm x 50mm) Rect. Tube 1/4” (6mm) Wall
Bundle 5” x 5” pcs. 10” x 10” (500mm x 500mm)
325 100
6
3” x 3” (75mm x 75mm) Inconel
60 20
The following table gives examples of the optimum blade speeds for different materials.
Materials and Blade Speed
FEED RATE is the vertical speed at which the blade descends through the work-piece.
The FEED RATE Knob controls FEED RATE of the blade descent. The FEED RATE should be adjusted only in one direc-
tion (from “O” to required value). If you go too far, go back to “O” and come back up. To set FEED RATE for particular
cutting situations use the graph below, which represents the relationship
between FEED RATE, blade speed and blade pitch.
Example #1: It is known from Step 3 that optimum blade
pitch is 2/3, and from Step 4 that blade speed is 200 ft/min
(60mm/min). From the Graph on the left, the FEED RATE is
determined in the following way:
1. On the horizontal axis (blade speed axis), find
200 ft/min (60mm/min).
2. Find the point where a ver tical line from 200 ft/min
(60mm/min) would intersect the 2/3 blade pitch curve
3. From this intersection point run horizontally left to the
ver tical (FEED RATE) axis, to ar rive at 1.8 in/min
(45mm/min) FEED RATE. Thus 1.8 in/min (45mm/min)
is the FEED RATE for cutting 8” (200mm) diameter 1045
Carbon Steel when the optimum 2/3 pitch blade is used.
Feed Rate Calculation