Hyd-Mech H28A-120, Руководство по обслуживанию и запасным частям

Страница: 35 / 88

2.7
AUTOMATIC OPERATION
To enter AUTO MODE, the FIXED VISE must be closed, putting the saw in SINGLE CUT MODE. When the AUTO MODE
key is pressed, the red indicator will come on. The screen will change to the JOB display window as shown below and will
be ready for editing or starting a new job. All manual functions will be disabled.
PROCEDURE FOR EDITING OR STARTING A NEW JOB IN AUTO MODE
1. In AUTO mode, key in a job number from 0 to 99,
the number of pieces to be cut, the number of pieces
already cut, and the length, pressing enter after each
value. If the number of pieces cut equals or exceeds
the number required, the cycle will not start. If the job
number has previously been programmed, the number
of pieces, length, and number cut will be displayed. To
navigate through the values, use the cursor keys. The
values displayed may be edited by using the numeric
keypad and pressing enter. The job will then be stored
in memory with the new values.
The job is now ready to start to run or other jobs can be
programmed at this time. To run a certain job, press the QUEUE
key and then CLEAR to clear the QUEUE. Move the cursor to
the 1
st
job and key in the desired JOB #.
2. After the values are entered, press the CYCLE START
button. The Material Height Prompt Screen appears.
3. Set the material height using the Head Up & Head Down
push buttons and then press enter. Position the blade
about 3/8” above material.
4. The display window will prompt you to start the blade
for a trim cut (if the “Trim Cut” parameter has been
selected).
When the AUTO CYCLE commences, the screen will change to
the “Auto Mode Status” screen and the following events will take
place:
1. A trim cut will be performed.
2. After the trim cut, the shuttle will advance the material to
the LENGTH value.
3. The saw will now cut the material to the LENGTH value
compensating for the thickness of the blade.
4. Steps 2 and 3 will be repeated for the given number of
pieces to be cut.
5.
At the completion of the job, the machine will shut off.
NOTES:
1. The CYCLE PAUSE key is used to pause a job in
progress. To resume the job, press the CYCLE START
key and the AUTO CYCLE will resume.
2. If PIECES CUT equals or exceeds NUMBER OF
PIECES, AUTO CYCLE will not start.