Hyco SpeedFLoW UnVenTed WATeR HeATeR
ModeLS SF10K (10 Litres) And SF15K (15 Litres)
1. InTRodUcTIon
Thank you for purchasing a Hyco Speedflow unvented water heater. This product
operates at mains water pressure and can supply hot water to two or more basins
using ordinary taps.
cAUTIon
THe SpeedFLoW MUST Be InSTALLed And MAInTAIned By
A coMpeTenT peRSon In AccoRdAnce WITH cURRenT
eLecTRIcAL And pLUMBInG ReGULATIonS.
IT IS eSSenTIAL THAT THe encLoSed pReSSURe ReLIeF VALVe
IS FITTed
MAKe pLUMBInG connecTIonS WITH FLeXIBLe STAInLeSS
STeeL HoSeS To FAcILITATe FUTURe MAInTenAnce
ALWAyS FIT THe HeATeR THe coRRecT WAy Up
(pIpeS SHoULd Be AT THe Top)
USe LoWeST AccepTABLe TeMpeRATURe SeTTInG To SAVe
eneRGy And RedUce LIMeScALe
do noT connecT To poWeR UnLeSS UnIT IS FULL oF
WATeR – open TAp And ALLoW WATeR To FLoW FReeLy
To cLeAR AIRLocKS
do noT SWITcH poWeR on IF WATeR In HeATeR oR pIpeS
coULd Be FRoZen
2. InSTALLATIon (WALL MoUnTInG)
The Speedflow is normally fitted immediately below the outlet to be supplied, but
it can be mounted above or to the side of the outlet provided it is vertical with
the pipe outlets at the top. The unit can either be placed directly on the floor or
fixed to a wall using the mounting bracket supplied.
enSURe THe MoUnTInG SURFAce IS STRonG enoUGH To
SUppoRT THe SpeedFLoW IncLUdInG THe WeIGHT oF
THe WATeR.
The 10 litre model (SF10K) can typically serve 1 or 2 sinks, and the 15 litre model
(SF15K) can typically serve 2 or 3 depending on simultaneous usage.
1
