Hybrid UTILIGHT SGN LED, Руководство по установке и обслуживанию

Страница: 12 / 16

12/16 www.hybryd.eu
MOUNTING DIMENSIONS C146 (mm)
20x10 30x15 40x20
205
180
(46)
2x 16
45
58 24
205
156
12
180
58 24
2x 16
(46)
305
45
220
(27)
70 24
2x 16
305
206
22
220
70 24
2x 16
(27)
405
45
220
(27)
120 24
2x 16
405
256
22
220
120 24
2x 16
(27)
LED INDICATORS AND LUMINAIRE CONTROL
All self-contained UTILIGHT luminaires are equipped with two LED indicators (red and green) and a magnetic switch. The two LED indicators are used to signal
the luminaire state as well as with the magnetic switch (marked on luminaire with TEST) are used to display a menu and run specific luminaire functions. These
functions and state signalling are only available on a maintained line.
Access to manual luminaire control is available by closing and holding a magnet near the magnetic switch (marked TEST). Entering the menu is signalled
by three alternate led blinks – red, green, red after which seven green LED blinks appear which mean each of the seven functions:
1 – start functional test (test A),
2 – start full test (TEST B),
3 – turn on/off Inhibit mode,
4 – disable/enable automatic test execution,
5 – present luminaire address (CT only),
6 – switch between maintained and non-maintained mode,
7 – reset luminaire state (including faults).
Removal of the magnet during or after each green led illumination is equal to running the specific luminaire command/function.
Entering
menu
Luminaire functions
Removing the magnet executes command
Leaving
menu
re
d
● ○ ● ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ● ○
gr
een ○ ● ○ ● ○ ● ○ ● ○ ● ○ ● ○ ● ○ ● ○ ○ ●
TEST
A
TEST
B
Inhibit
Disable/enable aut
oma
tic
tes
t e
xecution
Pr
esent luminair
e addr
ess
Maint
ained/non-maint
ained
mode
Luminair
e r
ese
t
TIME
After removing magnet:
Command accepted Command not accepted
red
○ ○ ● ●
green
● ●
○ ○
LUMINAIRE STATE SIGNALLING
green red LED indicators
● ○
Luminaire operating properly, battery fully
charged
●/● ○
Luminaire operating properly, battery being
charged
○ ●/●
Test being executed
○ ●
Control module malfunction, light source fa -
ilure, battery disconnected
○ ○
Emergency operation
○ – off, ● – on, ●/● – blinks
WARNING
!!!
Before any installation or maintenance operation is performed on the luminaire the power supply should be disconnected.
All installation and maintenance procedures can be performed only by qualified, properly trained and if appropriate, certified staff.