Hy-Gain DX-88, Инструкция по эксплуатации

Страница: 10 / 30

10/12/15 METER TRAP
Capacitor
There is one 16 inch capacitor and two 13 inch
capacitors used in the 10, 12, and 15 meter
trap assembly.
The 3rd spacer should be centered between the
other two. Push the rain cap onto the top of
this tube and then slide this assembly into the
1" x 16" tube. Seat the rain cap over the 1 inch
tube.
DO NOT place the caplug on the 7/16" tube at
this time.
Select one 1" x 16" tube (Item 4), 7/16" x 19"
tube (Item 8), 3 spacers (Item 35), 1 rain ap
(Item 36), and 1 caplug (Item 34).
Push the spacers onto the 7/16" x
19"
tube and
adjust so that the top spacer is approximately
10 inches from the top end of the tube, and the
bottom spacer is near the bottom end of the
tube.
Select a 1" x 13" tube (Item 5), 7/16" x 16"
inch tube (Item 9), 3 spacers (Item 35), 1 rain
cap (Item 36) and 1 caplug (Item 34) for each
assembly. Assemble the 13 inch capacitors in
the same manner as the 16 inch capacitors.
DO NOT place the caplug on the 7/16" tube at
this time.
Detail A
13" Capacitor Assembly
Detail B
16" Capacitor Assembly
Figure 3
10/12/15 Meter Capacitor Assemblies