Hy-Gain DX-88, Инструкция по эксплуатации

Страница: 11 / 30

Attaching Capacitors to Coil Assembly
Loosely assemble three pairs of 11/8" x 1"
clamps and three pairs of 11/8" x 7/16" clamps
as shown in Details A and B of Figure 4.
Select the 10/12/15 meter coil assembly (Item
13) and attach the capacitors onto the coil as-
sembly using the clamps as shown in Figure 4.
Dimensions C, D, and E will be set later on in
the instructions.
NOTE: Disassembly of clamps may be needed
to properly install them onto several inside
locations on the 10/12/15 meter trap assembly.
NOTE: The edge of each 11/8" x 1" clamp
should be flush with the edge of each coil
form. The rain caps should be pushed
completely on each 1" tube, and should be
flush with the 11/8" x 7/16" clamp. Tighten the
hardware on these 6 pairs of clamps. Push a
caplug (Item 34) on the top end of each 7/16"
tube.
Detail A
1 1/8" x 1" Mast/Capacitor Clamp
Detail B
1 1/8" x 7/16" Mast/Capacitor Clamp
Figure 4
10/12/15 Meter Trap Assembly