Fig 2
Fig 3
3.
Connect rotator cable to drive unit terminal board. See
Fig 3
.
CAUTION:
When using jacketed cable, be sure jacket of cable passes
thru the grommet to avoid moisture collection in the cable.
4.
Attach rotator cable and antenna cable securely to mast or tower,
and pass through building to TV or FM set.
NOTES:
See
Fig A
of the Important Safeguards section regarding
grounding of the lead-in cable for lightning protection.
CAUTION:
Before disconnecting old control box, make
note of each wire color and the corresponding
terminal connections. To reduce the risk of electric
shock, do not remove cover. No user-serviceable
parts inside. Refer servicing to qualifed service
personnel.
CONTROLLER INSTALLATION
1.
Determine the AC supply voltage and frequency in your country.
The US, Canada, Japan, Taiwan and South America are generally
120 VAC Hz. Europe, Africa, Australia and Asia (except above
mentioned) are generally 230 VAC 50 Hz. Your power company
will advise. Ensure the supplied wall plug power supply voltage
has the same input voltage as your household supply (±10%). If
not, contact your dealer.
2.
Plug the power supply into the controller and the household
supply. Observe the digital diagnostic display.
It should display:
•
60H
(or 50H in 50 Hz countries)
•
HH1
(to use with the supplied handheld remote control)
If the above are not correct refer to
Appendix A
to change.
3.
Disconnect the wall plug supply at the wall outlet. Connect the
cables between the controller and drive unit. See
Fig B
.
4.
Reconnect the AC supply to the controller. After 5 seconds it
will switch off. Switch back on by pressing any key on the front
panel or handheld remote control. Perform a synchronization by
pressing the sync button on the left of the front panel. This takes
slightly over one minute. The unit may now be operated from the
front panel using the up and down controls.
5. Digital Compass
This feature operates as follows:
The display
000
to
360
degrees where:
•
000
is North (fully CCW viewed by a bird)
•
090
is East
•
180
is South
•
270
is West
•
360
is North (fully CW viewed by a bird)
Fig B
Amplifier
Loop to allow full
turn of antenna
Adjust rotator
for free turn
thru full circle
Use 1-1/4 mast
for true Rotation
Coax cable
Electrical Tape
Drive unit
Green wire to #1
Grommet
Terminals
Grommet
Black wire to #2
Red wire to #3
Strip ends ½”
Red
Black
Green
Outer sleeve
Terminal Connections
Green wire to #1
Black wire to #2
Red wire to #3
18VAC
1 AMP
