HX TDT001Z, Руководство пользователя

Страница: 6 / 13

4.Install battery pack
5.Install the chain
6.Install the bike seat
-
07
- -
08
-
2 . Install brake lever
3. Install pedal
Turn the brake lever up to be almost flush with the instrument, and use an
Allen key to tighten the screw.
Left
a. Install the crank without tooth disc on the left shaft of the scooter, and lock it clockwise with
the screws provided
b. Install the pedal marked with "L" on the left crank, and pay attention to the thread direction
of the pedal is counterclockwise assembly
Remove the battery
a. Install the crank with chainring on the shaft on the right side of the car, and lock it clockwise
with the equipped screw;
b. Install the pedal marked "R" on the right crank, and pay attention to the clockwise thread
direction of the pedal during installation;
Install the battery
Align the battery with the guide rail
and insert it, insert it to the end and
turn the key clockwise to lock it
.
Remove the silicon cover, turn the
battery lock 90° anticlockwise and
pull the rope to take out the battery.
To install the chain, pass one end of the chain through the chainring and one end through the
flywheel of the motor, buckle the buckle into the chain, add a washer, and then clamp the circlip.
Note: It is better to tighten the chain and lock the buckle just to buckle both ends of the chain.
If it is too tight to buckle or too loose, the screw needs to be adjusted.
The adjustment method is as follows.
a. Use M19 wrenches to loosen the fixing screws on both sides of the motor;
b. Use an M10 wrench to adjust the tightness in the direction shown in the figure;
c. Just tighten the screws that fix the motor.
Loose Tight
Note: Pay attention to the safety line
when adjusting the height of the seat. The
safety line cannot exceed the saddle tube
to prevent danger!
Open the seat tube locking wrench, insert
the seat into the tube, adjust the height of
the seat and tighten the wrench.
Right