MP45.4525
12JUN97
MAINTENANCE
"NOT IN PARK/BRAKE" CHECK
LEVEL SENSING UNIT ADJUSTMENT
SURFACE
MOUNTING
BELOW THE SURFACE MOUNTING
SCREWS
REAR
THIS
SIDE
ON TOP
STICKER
UP
LEVEL SENSING UNIT
SPRINGS
CAUTION:
WHEN MAKING THIS CHECK, BLOCK
THE VEHICLES WHEELS SECURELY SO THE VEHICLE
CANNOT ROLL FORWARD OR BACKWARD.
problem or if there are other problems or questions, con-
sult a qualified RV repair center, your vehicle or coach manufac-
Set the park brake. Switch the ignition to the "ON" position.
Press the "HYD" button one time. Release the parking brake
and confirm that the "NOT IN PARK/BRAKE" indicator light
comes on. Reset the parking brake. The "NOT IN PARK/
BRAKE" indicator light should go out. Switch the ignition to
"OFF".
(3 USED)
(3 USED)
NOTE : If any of the above checks or inspections reveal a
turer, or HWH CORPORATION (1-800-321-3494) for service or repair.
Level the vehicle by placing a circular bubble level in the center
of the freezer floor or location within the vehicle that is to be
level. With the vehicle level, adjust the sensing unit until all
yellow lights are off. This is done by drawing up the corres-
ponding screw if the sensing unit is mounted below the surface,
as shown, or backing out the corresponding screw if the sens-
ing unit is mounted above the surface. Bump the sensing unit
to see that it has settled down in the level position.
