OPERATING PROCEDURES
MP35505
25MAY95
ROOM RETRACT PROCEDURE
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF THE ROOM WHEN OPERATING.
1. Turn the igniton switch to ACCESSARY.
2. Press the "HYD" BUTTON.
NOTE: To retract the room the HYDRAULIC OPERATION
LIGHT must be illuminated. A WARNING LIGHT does NOT
need to be on.
4. To retract the room press and hold the ROOM CONTROL
SWITCH in the RETRACT position. When the room is fully
retracted, release the ROOM CONTROL SWITCH.
NOTE: Releasing the ROOM CONTROL SWITCH will halt
the operation of the room.
5. Press the "OFF" Button or let the system continue to STORE.
7. Turn the ignition switch off.
8. Engage all room-locking devices.
9. If the room will not retract see the MANUAL ROOM RE-
TRACT PROCEDURE.
Room-locking devices should be locked while
traveling.
IMPORTANT:
NOTE: The room can be retracted ten seconds after the
Leveling System is put in the STORE mode. This will inter-
rupt the STORE mode unitl the ROOM CONTROL SWITCH
is released. The Leveling System will continue to STORE
starting from the beginning of the program.
IMPORTANT: Do NOT hold the ROOM CONTROL SWITCH
in the RETRACT position for more than ten seconds after the
room is fully retracted. If either side of the room stops moving
3. Turn the KEY SWITCH on the room extension operator’s
panel to the "ON" position. (See Figure 1)
release the CONTROL SWITCH immediately.
6. Turn the KEY SWITCH to the off position and remove the
key. (See Figure 2)
FIGURE 1
RETRACT
ON POSITION
KEY SWITCH
OFF
ON
EXTEND
FIGURE 2
RETRACT
ON POSITION
KEY SWITCH
ON
OFF
EXTEND
