HWH 225 Series, Руководство оператора

Страница: 10 / 31

OPERATING PROCEDURES
ROOM EXTEND PROCEDURE
CAUTION:
IMPORTANT: Extending or retracting any leveling
jacks when the room is extended is not recommended.
IMPORTANT: It is recomended to level and stabilize
the vehicle before extending the room.
2. Follow the LEVELING AND STABILIZING PROCEDURE.
the room remove it before extending the room.
CAUTION:
extend the room.
be illuminated.
7. To extend the room, press and hold the
ROOM CONTROL SWITCH in the "EXTEND" position
until the room is fully extended.
halt the operation of the room.
8. Push the leveling system "ON/OFF" switch to "OFF".
9. Turn off the ignition switch.
OPERATING THE ROOM WITH ANY
ROOM-LOCKING DEVICES LOCKED OR THE MANUAL-
RETRACT WINCH ATTACHED CAN CAUSE PERSONAL
INJURY AND VEHICLE DAMAGE. IT IS THE OPERATOR’S
RESPONSIBILITY TO ENSURE THAT ALL ROOM-LOCKING
DEVICES AND THE MANUAL-RETRACT WINCH ARE
DISENGAGED BEFORE OPERATING THE ROOM.
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
4. Turn the ignition switch to ACCESSORY.
IMPORTANT: Do not use a room extension support
when the vehicle is supported by the leveling system.
NOTE: If the MANUAL RETRACT DEVICE is attached to
NOTE: Make sure there is adequate clearance to fully
NOTE: To operate the room, the POWER ON LIGHT must
NOTE: Releasing the ROOM CONTROL SWITCH will
5. Push the leveling system "ON/OFF" switch to "ON" if the
POWER ON LIGHT is not illuminated.
after the room is fully extended or stops moving.
in the "EXTEND" position for more than ten seconds
of the room, do not reverse direction of the room until
after the room is fully extended. This assures proper
Hold the switch to "EXTEND" three or four seconds
pressurization of the cylinders.
Do not hold the ROOM CONTROL SWITCH IMPORTANT:
NOTE:
During normal operation
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
has been fully retracted.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
1. The park brake must be set. The room will not
operate if the park brake is not set.
MP35.206J
13FEB04
6. Push and hold the Travel Clamp switch to UNLOCK
until the Travel Clamp is fully retracted. The clamp will
shut of automatically when fully retracted. The room
cannot be extended until the clamp is fully retracted.
ROOMS WITH TRAVEL CLAMPS