Huvema HU 410 x 800 VAC TOPLINE, Инструкция по эксплуатации

Страница: 9 / 30

Operation Manual of Horizontal Lath
9
1-4 Protection of the Chuck
The lathe is equipped with the guard of the chuck (option), which is suitable for the
standard chuck.
In case the chuck guard is equipped on the lathe, it should be in a closed status
before the spindle is running.
1) When the machine is equipped with larger chuck, the chuck guard should be
replaced with one which has corresponding diameter with that of the chuck.
It is suggested that claws cannot extend out the outer diameter of the chuck in order
to avoid bump with the chuck guard. For the sake of safe operation, always take care
not to extend claws out of the outer diameter of the chuck.
2) When the face chuck is used, the chuck guard should be removed. If it is indeed
required by customer, the special chuck guard can be provided but it should be
confirmed that only the face chuck is used and any case should be responsible by
customer himself.
1-5 The Use of Emery Cloth in Metal Processing Can Cause Danger
In all accidents occurred on the lathe, most are from the use of emery cloth to cause
breakage of fingers, or even to amputate occasionally.
When workpieces with different shapes are rotating on the lathe, if using emery
cloth to deburr, to polish or to process finished sizes, it can cause the accident when
winding emery cloth on the workpiece to be ground by two hands. If winding the
emery cloth on the finger or to make rough grinding, the finger could be seized firmly
to cause serious injury.