Huvema HU 410 x 800 VAC TOPLINE, Инструкция по эксплуатации

Страница: 25 / 30

Operation Manual of Horizontal Lath
25
7-1 Electric Control
The main switch of power supply of the lathe is located at the rear of the lathe.
When it is switched on, the lamp of power supply lights. There is the interlocked
switch inside the side cover to switch off power supply when the door is opened.
7-2 Speed of the Spindle
Only when the handle (3) in the “A” position, the handle (1) can changed to the
“X” position..
Warning: The spindle system is not allowed to change speed in motion.
7-3 Operation of the Carriage Apron
The apron handle is pushed to the front of the limit position, lift the black bakelite
handle and counterclockwise rotate the handle to the limit position, realized cross feed
cutting movement.
The apron handle is pulled out the last position, lift the black bakelite handle and
counterclockwise rotate the handle to the limit position, realized longitudinal feed
cutting movement.
The apron handle in the middle position, lift the black bakelite handle and
clockwise rotate the handle to the limit position, realized the thread cutting
movement.