HUSTLER FasTrak 36, Руководство пользователя, Страница: 29 / 32

This section contains sources of additional literature
concerning your tractor. Literature should be ordered from
your Hustler dealer or direct from indicated source.
Parts Manuals
If you would like to order a Parts Manual for a particular
tractor, the Hustler part number for that manual is listed in
the following chart. Please contact your Hustler dealer to
order the manual.
PRODUCT LITERATURE
Parts
Model Manual List
Model Number P/N Price
FasTrak 36/42 927343, 927350, 927368 333559 $22.50
FasTrak 44/52 926501, 926519, 926527, 926592 365262 $22.50
926600, 926774, 927442, 927459
When storing the unit at the the end of the mowing season, the following
steps should be taken to ensure readiness for the next mowing season.
1. Remove all grass, dirt, and trash from tractor and mower. Clean
tractor and mower and touch up all scrapes with Hustler spray paint.
IMPORTANT:
Wash the machine with a mild detergent and water.
Do not pressure wash the machine. Avoid excessive use of water,
especially near the control panel, engine and the integrated
pump/motor units.
2. Install new air filter per Engine Owner’s Manual.
3. Check thoroughly for any worn or damaged parts that need
replacing and order them from your dealer.
4. Thoroughly lubricate machine, according to lubrication instructions.
5. Block tractor up so weight is off tires.
NOTE:
Do not deflate tires.
6. Remove the battery from machine
A. Clean battery
B. Check the electrolyte level
C. Charge the battery, if necessary
D. Store battery in a cool, dry place (do not expose to freezing
temperatures)
E. Always keep the battery fully charged. (Especially important to
prevent battery damage when the temperature is below 32
o
F.)
7. Perform separate engine preparation as listed below.
8. Store tractor in a clean, dry place.
Preparation of engine for storage
When engine is to be unused for long periods, proceed as follows:
1. Run engine for a minimum of 15 minutes.
2. Drain oil from crankcase while engine is still warm.
3. Refill with fresh oil of proper viscosity.
4. Drain fuel tank and run the engine until it stops from lack of fuel.
Gasoline evaporates if left in carburetor for long periods, forming
gum and varnish deposits in carburetor. These deposits will cause
engine flooding and loss of power.
5. Remove and replace fuel filter if not done in previous 100 hours.
6. Remove spark plugs and pour a tablespoon of engine oil into each
spark plug hole, Install plugs, but do not reconnect plug leads.
7. Crank engine with starter at least a dozen revolutions to distribute
oil over cylinder walls and valve mechanism.
8. Clean exterior surface of engine. Spread a light film of oil over any
exposed metal surfaces of engine that are subject to corrosion.
9. Clean dirt and chaff from cylinders and fins, blower housing and
muffler.
10. Check oil filler cap and fuel tank cap to make certain they are
securely in place.
11. Refer to engine manual for more information.
New season preparation
Before starting the tractor following post season storage, the following
servicing is required:
1. Clean tractor, removing trash and dirt accumulation.
2. Check engine oil level.
3. Fill fuel tank with fresh gasoline. Run machine at half speed for 5
minutes, checking operation of steering control lever. Stop engine
and check for oil leaks, loose fittings and so forth.
4. Tighten any bolts that have loosened and make sure all hair pins,
cotter pins and clevis pins are in place.
5. Install all safety shields and review safety precautions listed in this
manual.
6. Check and inflate tires to 8-10 psi.
7. Refer to engine manual for more information.
STORAGE
29 600643 02/06