4-4
M
aintenance
P/N 2400204_H
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
NEVER USE SHARP OBJECTS AROUND
COILS.
Use a soft brush or vacuum brush to
clean debris from coils.
Do not puncture coils!
Do not bend fins. Contact an authorized
service technician if a coil is punctured,
cracked, or otherwise damaged.
ICE
in or on the coil indicates the refrigeration
and defrost cycle is not operating properly.
Contact an authorized service technician to
determine the cause of icing, and to make
adjustments as necessary. To maintain product
integrity, move all product to a cooler until
the unit has returned to normal operating
temperatures.
CLEANING EVAPORATION PAN
The condensate water outlet for self
contained models empties into a limited
capacity evaporation pan.
Debris or dirt accumulation inside the
condensate evaporation pan will reduce the
pan’s evaporation capacity. The evaporation
pan waste water will overflow and spill onto the
floor if the pan capacity is reduced.
Unplug merchandiser before servicing. Always
wear gloves and protective eye wear when cleaning
evaporation pan.
Remove accumulated debris
from the evaporation pan. Be sure to remove
any dirt, debris or liquids from the pan.
REMOVING SCRATCHES FROM
BUMPER
Most scratches and dings can be removed
using the following procedure.
1. Use steel wool to smooth out the surface
area of the bumper.
2. Clean area.
3. Apply vinyl or car wax and polish surface
for a smooth glossy finish.
4. Make sure proper cleaning procedures are
followed. Lights and fans MUST be turned off
when a case is cleaned and MUST be allowed to
dry before turning power back on.
5. Do not use a pressure nozzle to clean inside
of case.
Evaporation Pan is Hot!
and poses risk of bodily injury
–
Always wear gloves
and protective eye wear when servicing. Turn off
evaporation pan heater, and allow pan to cool.
PRECAUTION
CLEANING PRECAUTIONS
Do not use high pressure water hoses
NEVER INTRODUCE WATER ON SELF CONTAINED
UNIT WITH AN EVAPORATION PAN
NEVER USE A CLEANING OR SANITIZING SOLUTION
THAT HAS OIL BASE (these will dissolve the butyl
sealants) or and AMMONIA BASE (this will corrode the
copper components of the merchandiser)
TO PRESERVE THE ATTRACTIVE FINISH:
Use a water and a mild detergent for the exterior only
Do NOT use a chlorinated cleaner on any surface
Do NOT use abrasives or steel wool scouring pads
(these will mar the finish)
Do not introduce water faster than waste outlet can drain
When Cleaning:
