Rev. 0909
9
cleaning glass and Mirrors
Only use a soft cloth and water for cleaning any glass
or mirrored components. Be sure to rinse and/or dry
completely.
never use hot water on cold glass surfaces! it may
shatter and cause serious injury!
Allow glass surfaces
to warm first.
Plexiglass and acrylic care
Improper cleaning not only accelerates the cleaning cycle
but also degrades the quality of this surface. Normal daily
buffing motions can generated static cling attracting dust
to the surface. Incorrect cleaning agents or cleaning cloths
can cause micro scratching of the surface, causing the
plastic to haze over time.
cleaning
Hussmann recommends using a clean damp chamois, or a
paper towel marketed as dust and abrasive free with
210
®
Plastic cleaner and Polish
available by calling Sumner
Labs at
1-800-542-8656
. Hard, rough cloths or paper towels
will scratch the acrylic and should not be used.
antistatic coatings
The
210
®
has proven to be very effective in not only
cleaning and polishing the Plexiglas surface, but also
providing anti-static and anti-fog capabilities. This product
also seals pores and provides a protective coating.
Maintenance
BEFORE SERVICING
Disconnect both Attachment Plugs to
completely De-energize unit.
Failure to disconnect both plugsmay result in
damage to equipment, serious personal injury!
This includes (but not limited to) Fans, Heaters,
Thermostats and Lights.
Replacing fluorescent lamps
Fluorescent lamps are furnished with moisture resistant
lamp holders, shields and end caps. Whenever a florescent
lamp is replaced, be certain to reinstall the lamp shield and
end caps over the lamp. The lamps supplied are single
slim-line or bi-pin type with or without starters.
ENCAPSULITE
SHATTERPROOF COATING - SA 10645
Complies with FDA USDA
& OSHA Regulations
for replacement call:
1-800-395-9229
Turn switch off then on after replacing bulb
NSF
U R
R
evaporator fans
The evaporator fans are located at the center front of these
merchandisers directly beneath the display pans.
copper coils
The copper coils used in Hussmann merchandisers may
be repaired in the field. Materials are available from local
refrigeration wholesalers.
Hussmann recommends using #15 Sil-Fos for repairs.
tips and troubleshooting
Before calling for service, check the following:
1. Check electrical power supply to the equipment for
connection.
2. Check fixture loading. Overstocking case will affect
its proper operation.
3. If frost is collecting on fixture and/or product, check
that no outside doors or windows are open- allowing
moisture to enter store.
FOR PROMPT SERVICE
When Contacting the Factory regarding problems.
Be sure to have the Case MODEL and
SERIAL NUMBER Handy. This Information
is on a plate located on the case itself.
user information (cont'd)