Hussmann Impact M1GLE-93, Инструкция по сборке

Страница: 5 / 10

7
Position Second Case
Alignment pins guide the
mating of the frames.
Insert
Cap Screw – 3
through Flat Washer – 4 ,
then through frame
into nut retainer.
Add Flat Washer –- 4 ,
Lock Washer –- 5 and
Hex Nut – 6.
Tighten to
draw side frames together.
8
From the front of one case,
use a long (10
1 /
2
in.) bit to
drill a
3
/
8
in. hole in each
end frame behind honey-
comb. Drill through both
cases. On each side, insert
Cap Screw – 7
through
Flat Washer –- 4
, then
through both frames.
Add Flat Washer –- 4 ,
Lock Washer –- 5
and
Hex Nut – 6.
Tighten to
draw frames together only
until space between PTM
measures 10
1
/
4
inches.
A
NYTHING LESS THAN
10
1
/
4 INCHES WILL
DAMAGE THE CASES
.
M1LGE-93 Joining P/N 0503478_A
5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM
Figure 7 — Location of Cap Screws in Side Frames
Figure 8 — Drill Holes in Back Frame
Figure 6 — Move Second Case
Cap Screw
Metal
Washer
Lock
Washer
Nut
Metal
Washer
Case
Frames
3
1
/
2
-inch
5 1 /
2
-inch
Minimum 10 1 /
4
inches between PTM
10
1
/
4