Hussmann Impact M1GLE-93, Инструкция по сборке

Страница: 4 / 10

5
Insert Alignment Pins
Each case ships with
alignment pins that are
inserted in end frames or
other mating surfaces to
facilitate positioning.
Refer to Figure 5 for
correct placement.
6
Apply Gasket
Apply Gasket – 2 as
indicated in Figure 5.
Gasket should be inset
1 /
4
-in from edge, and
extend up the sides to the
glass.
The same gasket arrange-
ment is used both cases.
Assure good adhesion of
gaskets by wiping the end
frame with rubbing alcohol
to remove any accumulated
dust and oils.
Apply silicone sealant
above gasket as shown in
Detail
Remove paper backing
before proceeding to next
step.
P/N 0503478_A
4
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
Figure 5 — Apply Gaskets
1
in.
Gasket
(24 mm)
Insert
Alignment Pins
Insert
Alignment
Pins
Apply Gasket up to
Glass onEach Side
IMPORTANT
• Do not stretch gasket, especially around corners.
• Do not butt gaskets; always overlap them as shown.
• Remove paper backing after gasket has been applied.
• Perimeter gasket required by NSF.
A continuous bead of
silicone sealant/ caulk
may be used in addition
to gaskets on mating
surfaces but must not be
used in lieu of gaskets.
Detail