Husqvarna Viking Platinum Q 165, Руководство пользователя

Страница: 16 / 58

powerquilter 1650 Quilting Machine User’s Guide
| 15
Optional Accessory: Rear Handlebars, Display, and Laser Stylus
To install the optional rear handlebars and display
Â
IMPORTANT : Install the rear handlebars and display after the front handlebars and display have
been installed.
1.
Check that the machine is unplugged from the electrical outlet.
U
CAUTION : All power to the machine must be turned off when installing the rear handlebars. Failure
to do so can result in damage to the machine.
2. The rear handlebars come mounted to a bracket. Line up the four holes in the bracket with those on
the rear of the machine.
3. Slide the four bolts into holes until they stop. Hand tighten, and then use the 3 mm wrench to securely
fasten the handles to the back of the machine.
4. After the four bolts are in place, plug the small connector end of the cable into the port on the left side
of the display. Push the plug securely into place.
5. Securely plug the other end of the cable into the port on the back of the machine below
the handlebars.
NOTE : See the instructions that accompany the Rear Handlebars and Display.
Â
IMPORTANT : After the rear handlebars have been completely installed and plugged in, test them
by turning on the Platinum Q|165 and looking at the rear display. If nothing appears on the screen,
check that both the front and rear handlebar cables are plugged in securely, that your machine is
turned on, and that the power cord is plugged into the machine as well as a power source.