Husqvarna TR 650 STRADA 2013, Руководство по ремонту, Страница: 35 / 301

D.5
TR 650 TERRA 2013 - TR 650 STRADA 2013
H11667
1
2 mm
(0,8 in.)
4
2 mm
(0,8 in.)
H11668
2
3
4
H11669
2
2
1
H11670
1
2
Workshop Manual Ed. 09-2012
SETTINGS AND ADJUSTMENTS
Throttle cable adjustment
To check the correct adjustment of the throttle control cable, operate as follows:
- remove the reservoir and the filter box as outlined in the relevant sections;
- turn throttle twistgrip (1) and make sure that there is a clearance of approx.
2 mm (0.08 in);
- if this does not work, unlock the check nut (2);
- work on the nut (3) until you have about 2 mm clearance (0.08 in.);
- tighten check nut (2).
- reassemble all parts, in the reverse order compared to disassembly.
Operation with damaged throttle cable could result in an unsafe
riding condition.
When throttle control cables (4) are replaced, adjust new cables as previously
explained.
Throttle control
The throttle twistgrip (1) is located on the right-hand side of the handlebar:
Throttle position adjustment
The position of the control on the handlebar can be adjusted by loosening the
two retaining screws (2).
Do not forget to tighten the screws (2) after adjusting.
Front brake control
The brake control lever (1) is located on the right-hand side of the handlebar.
Position adjustment
The position of the control on the handlebar can be adjusted by loosening the
two retaining screws (2).
After adjustment, turn the handlebar as far as possible to the right
and make sure that the lever does not touch the bodywork
A stop switch, during the braking action, causes the stop light on the tail light
to come on.
Do not forget to tighten the screws (2) after adjusting.